1.When laying, avoid sudden twists and turns to prevent the ability to reduce water pressure;It should also avoid torsion, to prevent the water belt from turning and to remove the interlocking interface.
2.After bridging the water, avoid dragging on the ground. When changing position, try to move as much as possible to decrease the wear and tear on the water belt and ground.
3.Contact with oil, acid, alkali and other corrosive chemicals should be prevented.
4.In areas where there may be flame or strong radiation heat, cotton or hemp hose should be used.
5.Should be cleaned after use, no lining of the hose should be hung, dry after the coil is kept in a cool and dry place.
6.In the process of use, if there is a damaged hole, apply the water belt to wrap it tightly, and then darken or paste it as soon as possible.When any apparent damage occurs, the combat readiness should be withdrawn immediately.
7.When the vehicle needs to pass the water belt in the laying, the water belt should be installed in the water belt.
8.If you are required to pass the railway, you should pass under the railroad tracks.
9.The exterior of buildings in remote areas should be covered with a lining hose to avoid freezing.